Moin...
ich habe mal ein bißchen zu dieser Frage nachgelesen...
Mal unabhängig davon, ob die Baugleich sind, mal ein GANZ anderer Tip zu dem Thema:
Wenn du auf Hydraulic Lifters umrüstest, brauchst du eine passende Camshaft dazu, sonst wird das wohl nix mit dem runden Motorenlauf !!
Soo zumindest die Aussage bei den Ami's...
Hier mal der
Auszug:
If you run Hyd. lifters on a solid lifter cam and the lifters are adjusted as Hyd. should be the idle will be very rough if it runs at all.
If solid lifters are run on a Hyd. cam the vlaves will be very noisey unless the clearence is adjusted to ZERO.
The Hyd. lifter cam is designed for ZERO clearence and the solid designed for what ever the book calls for. The Hyd. cam does not have what is called a clearence ramp.
The bent push rods usually are caused by stuck valves and are intakes 90% of the time.
Also offentsichtlich war DAS als Umbau soo nie geplannt...
Gruß Tom